Not Logged In     Login  
 Release 22.0, Sept. 2008
 
Chapter : ch4. Coagulation Section : Unfractionated Heparin Therapy
  Protocols for Heparin Therapy Based on aPTT

  Online Excel Reference
Copyright (c) 2008-2010, Institute for Algorithmic Medicine, Houston, TX, USA. All rights reserved.

Overview :

Heparin therapy needs to be adjusted to maintain the patient in an anticoagulated state sufficient to prevent thrombosis, yet not result in excessive hemorrhage. Based upon changes in monitoring tests, heparin administration can be adjusted to keep the patient within the desired therapeutic range.

 

The aPTT is widely available for monitoring, with the decision points given as multiples of the mean for the reference range. However, different commercial aPTT reagents vary in their responsiveness to heparin, so that this process can be misleading. Therefore, it is recommended that the heparin response curve be studied, where a given test system's aPTT results can be plotted versus heparin levels.

 

Antifactor Xa levels can also be monitored, but this testing is often not readily available.

 

Initial heparin dosing:

(1) Give a bolus of 80 IU per kilogram.

(2) Start an infusion of 18 IU per kilogram per hour.

(3) Order an aPTT 6 hours after heparin bolus given.

 

Adjusting Infusion based on aPTT

aPTT

Adjustment

< 1.2 times mean of reference range

repeat 80 IU/kg bolus, then increase infusion rate by 4 IU/kg per hour

1.2-1.5 times mean of reference range

give 40 IU/kg bolus, then increase infusion rate by 2 IU/kg per hour

1.5-2.3 times mean of reference range

no change (therapeutic range)

2.3-3.0 times mean of reference range

decrease infusion rate by 2 IU/kg per hour

> 3 times mean of reference range

hold infusion 1 hour, then decrease infusion rate by 3 IU/kg per hour

 

where:

• The target for aPTT monitoring is reported as a multiples of mean for reference range.

• The therapeutic range is often given as 1.5-2.3 times the mean of the normal range.

• Check to see if actual body weight or ideal body weight should be used for calculations.

 

Ongoing monitoring:

(1) Order an aPTT 6 hours after any dosage change.

(2) Once 2 consecutive aPTTs are within the therapeutic range, monitor the aPTT every 24 hours and adjust infusion accordingly.

 

Example:

(1) reference range for aPTT: 20-36 seconds, with mean 28 seconds

(2) multiples of mean for aPTT: 1.5 times is 42 seconds, 2 times is 56 seconds, 2.3 times is 64 seconds.

(3) The recommended therapeutic range: 42-64 seconds

 

  References:

Bick RL. Heparin therapy and monitoring: Guidelines and practical parameters for clinical and laboratory approaches. Clin Appl Thrombosis/Hemostasis. 1996; 2 (suppl 1): S12-S20.

Cruickshank MK, Levine MN, et al. A standard heparin nomogram for the management of heparin therapy. Arch Intern Med. 1991; 151:333-337.

Hirsh J. Heparin. N Eng J Med. 1991; 324:1565-1574.

Hirsh J, Fuster V. Guide to Anticoagulant Therapy Part 1: Heparin. Circulation. 1994; 89:1449-1468.

Hirsh J, Raschke R, et al. Heparin: Mechanism of action, pharmacokinetics, dosing considerations, monitoring, efficacy and safety. Chest. 1995; 108 (suppl): 258S-275S.

Raschke RA, Reilly BM, et al. The weight-based heparin dosing nomogram compared with a "standard care" nomogram. Ann Intern Med. 1993; 119: 874-881.

 

 

   Online Excel | Reference TOP
     Pubmed Search For
Copy and paste the article title, or authors names into the search box